VTG OEM Harley Davidson Pull/Choke Control Assembly NOS EVO Sportster 29229-86

Part #: 29229-86

Harley-Davidson part number 29229-86 is a genuine Pull Choke Control Assembly. 

It is primarily a vintage or obsolete component used on early Evolution-era motorcycles, specifically for air cleaner and choke configurations.

• Assembly Type: Manual Pull/Push Choke (Enrichener) Control.
• Total Length: Approximately 12 inches (standard for this era of Sportster frames).
• Cable Travel (Inner Wire): Typically ~8-5/8 inches.
• Knob Material: Hard black plastic with "CHOKE" or a choke icon imprinted (depending on the production run).
• Housing: Black vinyl casing with a threaded mounting nut for the bracket.
• End Fitting: Plunger-style tip designed to thread directly into Keihin butterfly carburetors (pre-CV era).

Fitment: The exact fitment for Harley-Davidson part number 29229-86 is very narrow. It was designed specifically for the first two years of the Evolution Sportster.

• 1986–1987 XLH 883 (Sportster 883)
• 1986–1987 XLH 1100 (Sportster 1100)

Component Requirements:

This part is only an "exact fit" if your motorcycle still has its original factory intake setup:

• Carburetor: It is made for the Keihin Butterfly carburetor. It will not fit the CV (Constant Velocity) carburetors that became standard in 1988, as they use a different plunger and thread pitch.
• Mounting Location: It mounts directly to the original air cleaner backplate bracket specific to those two model years. 

Please make sure of fitment before buying.

NOS, did not open for pictures.

Selling as pictured, save on shipping by coming to store in Butler, PA

032026 CC