Coverage & Application

Coverage: Approximately 50-100 m²/litre, depending on the type of wood and degree of soiling.

Application: Product is ready to use. Do not dilute.

By hand:

• Moisten cloth with ProNature Care Oil
• Apply sparingly until the whole surface is covered.
  Wait 15 minutes
• Remove and dry off any excess that has not been absorbed thoroughly using a lint-free cloth, e.g. ProNature Mutton Cloth to avoid glossy spots and prolonged drying time
• Leave to dry for 1-2 hours and then dry polish with a lint-free cloth .
  

By machine:

• Moisten cloth with ProNature Care Oil
• Attach the moist cloth to a dry circular pad of a surfaces polisher (150 rpm).
• Continuously add more ProNature Care Oil until the entire surface is covered with oil.
• Wait 15 minutes
• Remove and dry off any excess that has not been absorbed thoroughly using a lint-free cloth e.g. ProNature Mutton Cloth or a surfaces polishing machine (soft pad) to avoid glossy spots and prolonged drying time.
• Leave to dry for 1-2 hours and then dry polish with soft pad.
  Should a second coat be desired, repeat procedure as above after the minimum drying time of 12 hours.

If the surface is very soiled:

• First application of ProNature Care Oil should be more liberal: approx. 1 litre to 15 m².
• Then work crosswise with a red or green pad (150 rpm) removing all stubborn dirt.
• Remove surplus after about 15 min using a lint-free cloth or a surfaces-polishing machine (soft pad)
• Continue as described above. The best results are achieved if the surface is left unused for 12 hours.