920458096 Fits 1-9

An invisible zipper is always inserted before stitching the garment
seam. The Invisible Zipper Foot has two grooves underneath the
foot to accommodate the zipper coils and hold them in place as
you stitch. Buy a zipper that is at least 1 ¼" (3 cm) longer than
the zipper opening.
1. Mark the length of the zipper opening on the seam allowance and on the zipper. The excess length should be at the bottom of the zipper. Snap on the Invisible Zipper Foot.
Select center needle position straight stitch. Length 2.5–3.0.
2. Unzip the zipper.
3. Place the right part of the zipper on the fabric right sides together. The coil should be
on the seam line and the top stop of the zipper ¾" (2 cm) below the cut edge of the
fabric.
4. Finger press up the zipper coils and lower the presser foot with the zipper coils in the right
opening under the foot. Adjust needle position to align the needle with the needle guide
on the front of the foot. Backstitch and sew. Stop at the mark on the zipper and seam
allowance and backstitch to tie off.
5. Place the left part of the zipper right sides together with the left side of the garment. Lower the
presser foot with the left opening over the zipper teeth. Make sure that the needle is perfectly
aligned with the needle guide in front of the foot again. Sew in the same way as the first side.
6. Pull up the zipper pull. Place the fabric with the zipper right sides together. Snap on the
regular Zipper Foot E to the left of the needle. Adjust needle position to the right. Pin
the rest of the fabric below the zipper right sides together. Sew the seam from the lower
edge and up to the zipper overlapping the backstitched seam. If the zipper is too long,
whipstitch across the zipper teeth 1 ¼" (3 cm) below the inserted zipper length. Cut
away excess zipper below the whipstitching.