Trail-Safe™ FJ80 Knuckle Ball Wiper Seal Kit

The Trail-Safe™ Knuckle Ball Wiper Seal is a double sided seal that keeps grease in and dirt out, all while eliminating the use of the OEM felt and rubber. Since it is made from seal-grade polyurethane, not UHMW, the seal is pliable enough to stretch over the knuckle ball during installation. This eliminates the need to cut the seal for installation which allows water to enter the knuckle ball and for grease to escape.

Trail-Safe™ Knuckle Ball Wiper Seals are without a doubt the best in the industry. No other design is comparable in performance and quality.

Note:. Trail-Safe™ Knuckle Ball Wiper Seals are sold in pairs and one kit will complete one front axle.

Specifications:

• Primary and secondary rod seal to insure that fluid leakage would never be an issue
• Two wiper seal design
• Triple Lip Piston Seal for consistent steering with no drift or fluid bypassing the piston
• The bushing allows the rod to absorb much higher side loads
• 4340 chromoly steel piston shaft
• Our Double Ended Ram have a 6", 8", or 10" stroke x 2.25" bore x 1.125” rod
• The cylinder has a black zinc-plate finish while the rod has 3/4x16 female threads on each end and is made entirely out of 4340 chromoly material
• The 6 inch ram and clevis kit has 6 total inches of travel and is perfect for Toyota's and narrowed Dana 44's.
• The 8 inch ram and clevis kit has 8 total inches of travel and was made to work with Dana 44's and custom length Dana 60 applications.
• The 10 inch ram and clevis kit has 10 total inches of travel and is used for buggies and comp rigs with up to 45 degree steering radius.
• 1,650 PSI of pressure at 4.5 gallons per minute

Kit Includes:

• 6, 8", or 10"" Double Ended Ram and Clevis Kit
• Orbital (100ml, 125ml, or 160ml)
• Full Hydraulic Steering Pump with Pulley
• Tie Rod Kit
• Double Ended Ram Mounting Kit
• Steering Column
• Orbital Mounting Kit
• Reservoir with Filter
• Reservoir Bracket
• Cooler
• Power steering belt
• Complete hose kit
• All necessary hardware